don't forget to re-download DayTarget on post one.
here is mine, beautifully closed.
Grid - New indicator that replaces chart grid 60 replies
Grid (not grid system) or horizontal lines indicator 6 replies
Scalping Expanding Hedged Grid 70 replies
Grid, Burst Grid, Grid Risk and Grid Profit 1 reply
Double Time Grid and Pip Grid 0 replies
Disliked{quote} good, let's continue fine tuning it. don't forget to re-download DayTarget on post one. here is mine, beautifully closed. {image}Ignored
Disliked{quote} Nice work. I have download 5e onto my roboforex test local VM. What changes have you made to 5e? Will do the same on the PaxForex VPS once I hit the target of 0.5% of 100k demo account. Can't find where to make a smaller demo on PaxForex they seem to default to 100k. I like the spreads on Pax, I am sure it would have to have better results. looking forward to the weeks ahead.Ignored
Disliked{quote} I will add a parameter where you can enter an offset pip value. What happened is that DayTarget targeted forced and close all positions but after closing all it found out you are a bit off of target and then it reopens again to get the missing amount. I designed it like that, it is normal. to control it, an offset pip parameter will help. If you get close all and then reopened again, then adding pips to the offset will eliminate it. note that by default DayTarget already has 1 pip offset. it means your broker is adding too much slippage/latency...Ignored
Disliked{quote} 103_022 version upgrade1 an analysis is required to optimize Testers ... for two weeks and set appropriate parameters ... I do it every week .. . EXG103 upgrade1.ex4 {file}Ignored
Disliked{quote} I did updated the target calculation when Closure_Forced is selected and more than one day is needed to target. soon I will handle the issue when weekends are in and I will add a parameter for pip offset. now offset is one pip.Ignored
Disliked{quote} Bauta, not sure if you have already explained these ...Ignored
bauta
None: DayTarget does not targets, it just go to closure mode on news events.
Closure_Mode: When B >= A the entire MT4 goes to closure mode. Applies to EG104 only. This method slow exposure and closes positions at break even. It does not close a cycle for a loss.
Closure_Forced: When B >= A the terminal goes to Closure Mode, then when C >= A DayTarget closes all your opened positions. This Forced method applies to any position on your terminal, opened by EG104 or no. When C >= A DayTarget may close cycles for a loss keeping C > A. I do recommend this method, it clean up the terminal and allow you to start fresh next server day.
Forced_Mode: When C >= A DayTarget closes all positions regardless of cycles been at loss or profit, this target type does not use closure mode.
DislikedDears, What's the difference between Closure mode and Closure_force!?Ignored