DislikedThanks Peter.
Anybody know a simpler method than all this. I recall getting email up and working without signing up for a gmx account, or going through the rigmarole involved in method 2 in the writer's doc.
This is not a big issue. I can always simply leave it up to those who want to use the facility I am going to add, to sort it out for themselves.
Ignored
Tazmaan et all
For your result can you let me know what you are doing and what settings so as to arrive at the results ie OOTB , closing all trades at end of USA session
For example I am using OOTB and Alpari 5D
None of mine have closed today and at one point I was up to 150pips but now back down to 100 pips
In this tab, the electronic mailbox is set up. Later on, these settings will be used to send message by the expert advisor command or by a triggered alert. To start setting up of email, the "Enable" must be enabled and the following fields must be filled out:
- SMTP Server — address of the SMTP server and port used. This server will be utilized to send the message. The record must be made in the following format "[server web address] : [port number]". For example, "smtp.your_email_provider.com:25" where "smtp.your_email_provider.com" is the server web address, "25" is the port number.
- Login — a login to be authorized on the trade server. Normally, it is an electronic mailbox. Example: your_name@your_[color=#ffff...vider.com
- Password — a password to be authorized (mailbox access password).
- From — the email address, from which the message will be sent. In this field, there must be name and emailing address on the mail server, the SMTP of which will be utilized. The name usually coincides with the first part of the electronic address, but the name can be omitted. Example: your_name, your_name@your_[color=#ffff...vider.com
- To — the email address, to which the messages will be sent. The "Your Name" part of the address can be omitted. Generally, in the "To" field, any really existing email can be specified. Example: any_name, your_name@your_[color=#ffff...vider.com
Attention: Only one email address may be specified for either of fields "From" and "To". Several emails given with or without separators will not be accepted.
The "Test" sends a test message using the settings specified to test their workability. If it has been tested successfully, the "OK" button must be pressed to apply these settings. In case the test did not succeed, it is recommended to check all settings again, restart the temrinal and resend the test message.