MACD / Indicator problem

GDP/USD MACD indicator window

Any suggestions much appreciated.

I have eight currency pairs marked with various MA’s.

Each has an indicator window containing three indicators.

RSI, Stochastic, and MACD.

On the indicator window to the right, there are five values present;

A -0.0006 (changes), a 20, a 0.00 - moves up and down, an 80, and a 0.0003 (changes).

Until yesterday, all appear to be working correctly,

And then the indicators on the GDP/USD, only, changed.

The 0.00 disappeared, the variable values changed to a fixed 0 and 100.

The 20 and 80 remained unchanged.

The ‘slow’ and ‘fast’ indicators on the MACD began diving below and above, out of sight, in the indicator window.

I have :

Removed all indicators and re-applied them.

“ ” “ ” , and re-booted.

Removed the chart and started from a new chart.

The slow / fast indicators now remain visible in the indicator window.

I have checked the setting against those charts that seem to be working correctly, and they are all the same.

When I display two charts side by side, the indicator window of the GDP/USD are different than the other charts.

Any assistance much appreciated.

you might want to post a screenshot

Not sure if this is your issue, but :
Open the parameter window of your misbehaving indicator to make sure the "Fixed Minimum" and "Fixed Maximum" boxes are NOT checked. If something went haywire and bogus numbers are in there the indicator window will show an area that may be out of the indicator's range. Also you may have to reset you zero level manually by clicking the "Levels" tab of the indicator parameters window and clicking "Add", then typing a zero.
Hope this helps!

May be a computer memory problem!

I began by opening the,

Custom Indicator - MACD with Histogram, dialogue box.

I clicked on ‘Reset’ in all the tabs.

Closed and re-opened MetaTrader

Opened MACD dialogue box

Common Fixed min, not checked - greyed out value = -0.0012
Fixed max, not checked - “ ” = 0.0008

Inputs, Standard 12, 26, 9

Levels, Clicked Add, 0.0 appeared

Clicked OK Clicked Close

The zero line is back. Not 0.00 as it was before.

And the ‘slow’ and ‘signal’ lines remain within the indicator frame.

The variables, which I have discovered are the values of the histogram, are still 0 and 100.

The variables I never refereed to anyway.

I’m new to trading and am certainly not computer literate.

I much appreciate your responding and your help/suggestion Taters, thank you.

Thanks to all.