Wolfie/Matt:
Are you using QQE 1, 14, 3
Laguerre 0.8
Time: 0-24 ????
Are you using QQE 1, 14, 3
Laguerre 0.8
Time: 0-24 ????
Forex Trend Catcher EA 721 replies
trend catcher fib ea 5 replies
Early Trend Catcher Part2 46 replies
Early Trend Catcher 31 replies
Trend Catcher 5 replies
DislikedMaybe it is just my settings but the entry seems more than a bar or two late sometimes.
http://i5.photobucket.com/albums/y17...70/example.jpgIgnored
DislikedWolfie/Matt:
Are you using QQE 1, 14, 3
Laguerre 0.8
Time: 0-24 ????
Ignored
DislikedHi Gnat
Sorry to be a pain, but I am trying to set up the exact same indicators/ settings as your charts indicate, to also test, however I cannot readily find where the same ones you use can be found and their settings, plus is there a post decribing the ea settings you use?
Many thanks
RobIgnored
DislikedHallo DBallerz!
See the picture below. The signal was not yet ready to go long, although the timing looked really good, but that would have been discretion!
Greetz
GnatIgnored
DislikedThank you for the timely response. Do you wait for all of the idicators to line up or wait for the green/red arrow? How many trades are valid a day?Ignored
DislikedHallo DB!
You definitely have to wait for the QQEA signal. Then the Momentum will tell you about the strength of the move. Latest of the pack is the DMI and here I would say that a tendency in the right direction is just good enough.
Look to have the Heiken Ashi bars (the "candles" we use here) on the right side of the T3 line - above for long - below for short.
Then most of the initial system rules are on your side and yu can enter trades. Some knowledge about the pair you trade and the longer term trend comes in handy, amigo! LOL
ciao & leaving now for 4h
MattIgnored
DislikedImran has revised his Laguerre system so that triggers occur when the
two respective Laguerre lines cross. There is an EX 4 indicator download on this page:
http://forexfactory.com/showthread.p...ight=imransait
Visually, and perhaps actually, this might be a better Laguerre setup.
There is a single window with crossing lines. One can move the points of intersection horizontally by altering the gamma settings. I suspect that coding for this would be easier, too.
Whatchathink?
GlennIgnored