Help with Fibo Expansion

I am new to the MT 4 community and would appreciate some help. I am looking for an indicator/EA similar to the "Fibonacci Expansion" tool that allows the two lines to go beyond a 90 degree angle. Thank you in advance for your help.

just drag the center dot down between the outside points if what you are trying to do is make it a downward expansion. I f what you are trying to do is get a fib level past 100% in the fibo object properties->fib levels pane, click "add" and type in 1.618 etc. If this properties window does not open automatically when you add a fib to the chart just double click it once it is drawn an the window should come up. Check the in the "Object" section of the MT4 options window that "show properties after creation" is checked if you want the properties to be shown every time yo draw an object.
Hope this helps-
Taters

Taters,

Thank you so much for replying to my post, and for your help. I already know how to add the Fibo settings, but I didn't know about the other tip that you mentioned. I've followed your tip about the Options section and I learned something that solved one of my issues. So again, thank you for your help. I am actually using the FE in a variety of ways. One way requires the shortest line (when the FE is drawn on a chart) to move above the center swivel point. My MT 4 platform’s FE only goes up to 90 degrees. I am looking for an FE indicator that actually goes past the 90 degree point allowing me to pick arbitrary points above 90 degrees to use in my study.

Again, thank you so much for your quick response and your willingness to help. This community is so awesome.

...but by definition the expansion tool seeks to project the bounce from the retracement point (third dot). The 90 degree point is 100% of the move- the 38.2% expansion of 100% = 138.2.Thats what the regular fib tool is for.( You do know you can put in numbers over 100 in the fib tool...)
You will never ever get the third leg past 90 degrees.Maybe experiment putting in negative fib numbers and see if that gets you where you wanna go or explain your idea further.
Cheers,
T

Mr. T,

Thank you for your time, I really appreciate your help on this matter. I have attached a chart that will help in conveying what I'm looking for. The chart shows the typical use of the FE tool. What I'm looking for is an indicator that allows me to move the end from "C" to "D" while the ends at "A & B" remain where they are.

Have an awesome day, and again, thanks for your help.

Gunny D