Coder Help "array out of range"

I had a coder Alexander Voronkov from Ukraine helping me by adding two MA's to a EMZ indicator. Unfortunately I have not been able to get a hold of him for almost two weeks. My fingers are crossed that he and his family are safe.

I looked through the previous post talking about "array out of range", but I'm not a coder so they didn't help me.

Hopefully someone here can help.


The Indicator (EMZ_MAs) works fine. It even seems to work on live charts when add to an EA (via Fxdreema). I use it to draw a line on the chart when the two MA's cross.

Where the problem starts is when I run it in mt4's Strategy Tester. where it does not work. No lines a shown on the chart. The error that shows in the Journal when running the EA: "EMZ_MAs GBPJPY,M15: array out of range in 'EMZ_MAs.mq4' (76,36)"

I assume the problem is with the indicator, but I guess it could be the EA. Either way it would be great to be able to back-test some ideas

Here is the indicator. If there is no problem with it I can upload the EA if need be.

Here, I can run it in the tester, and you should leave author info in at the top

Thx jeanlouie,

I tested it going back 1 day on gbpjpy 15 min. chart, and it worked but it looked slow. So I tested it again going back 3 month. It's been running almost an hour and a half and the progress bar is only 1/4 of the way finished.

EA is a simple draw arrow when FastMA crosses above SlowMA.

Any ideas?

Also I added author info above. I wasn't sure about the proper etiquette.

Yes I noticed it's very slow, however you only mentioned the array issue as a problem.

I'm not looking into it much, but it's not as simple as a single ma crossover. It possibly could be made much faster, but your description is not just what it's doing.

Understood.

At the time, although it did not trigger in Strategy Tester, it ran at what seem to be a normal speed.

The run I started last night still has not completed. so unfortunately for me the result is the same. I can't back-test.

Either way thank you. You guys that understand code and help others are what makes this community strong.

I'll start another tread with my new issue.

Thx again for your time.