I have attached an EA I downlooaded from another forum. The attached EA basically works as follows:
System is simple:
- signal for enter - EMA8 is crossing EMA55.
Confirmation on Parabolic with default settings on the current timeframe (H1 or M30) and on M15 as well.
- exit on crossing EMA8 and EMA21.
This EA is very similar to a manual system i have been testing. However, it is little bit different in that I would like it to trade as follows:
Change the three EMA's to EMA-5, EMA-13, and EMA-62. I would like to modify the EA so that a trade is executed after the following three conditions are confirmed: 1. EMA-5 crosses EMA-13, 2. EMA-13 crosses EMA-62, and 3. The EMA-13 has a separation of 20 to 50 Pips from EMA-62. I would like to have this separation variable via adjustable setting in the EA setup. Thjje exit would be triggered when the EMA-5 and EMA-13 cross again or when the take profit level has been reached.
I'm don't know how complicated it is to do this, or if it even possible. Perhaps some of the experienced coders on the forum could look at this and let me know if it is possible and guide me thru making the changes.
Thanks in advance for any assistance.
System is simple:
- signal for enter - EMA8 is crossing EMA55.
Confirmation on Parabolic with default settings on the current timeframe (H1 or M30) and on M15 as well.
- exit on crossing EMA8 and EMA21.
This EA is very similar to a manual system i have been testing. However, it is little bit different in that I would like it to trade as follows:
Change the three EMA's to EMA-5, EMA-13, and EMA-62. I would like to modify the EA so that a trade is executed after the following three conditions are confirmed: 1. EMA-5 crosses EMA-13, 2. EMA-13 crosses EMA-62, and 3. The EMA-13 has a separation of 20 to 50 Pips from EMA-62. I would like to have this separation variable via adjustable setting in the EA setup. Thjje exit would be triggered when the EMA-5 and EMA-13 cross again or when the take profit level has been reached.
I'm don't know how complicated it is to do this, or if it even possible. Perhaps some of the experienced coders on the forum could look at this and let me know if it is possible and guide me thru making the changes.
Thanks in advance for any assistance.
Attached File(s)
EmaFibotf_v2.mq4
12 KB
|
368 downloads