Dislikedthat is very strange... does it give any errors ? what do the experts and journal tabs say when you load it.Ignored
In the 'journal' tab it loads both successfully too.
4 hour strategy (the nausbot - 4 hour trader) 11 replies
Why does 4 hour bar close 1 hour later than daily bar? 6 replies
average true range for 1 hour and 4 hour charts 2 replies
X-1102 1 hour , 4 hour and daily Tf trades 7 replies
Create a verticle line at certain hour for every certain hour 16 replies
Dislikedthat is very strange... does it give any errors ? what do the experts and journal tabs say when you load it.Ignored
DislikedIn the 'experts' tab it loads RonnieSignals successfully and also loads Macd-with-ema as well (??)
In the 'journal' tab it loads both successfully too.Ignored
DislikedHi jubu,
Same here.
No problem with the indicator, journal and expert tabs say everything has been loaded successfuly.
I can even see a red up arrow on EURUSD H1 (see attached chart).
So I assume everything works, but no other alerts have been triggered since then.Ignored
DislikedI can see there should have been two more signals sience that red arrow.
pfff... I really don't know what to say... mine works fine and it gives alerts and everything. Try restarting the MT, or try to change the TF to M30 and then back. Or here, try this one i added two more buffers for visual price of entering the trade. It should display the arrow under the candle and an x up the arrow 10 pips higher then the candle high. If this one doesn't work either then i really don't know that to say... Something's definetly wrong but i don't know what.....Ignored
DislikedIt seems the fat lady has sung.
No setup for the moment, waiting mode...Ignored
Dislikedit might be a good idea to go down to M30, or M15 charts. Use same model, but reduce SLs and TPs based on ATR... ATR1620,G/U H1=.0027, M30=.0018. So, 18/27x100= SL, and TP at 67 pips on M30 chart. Buy on M30...Ignored
Dislikedpip
can you explain more re ATR to find alternative SL and TP on the other timeframes or somewhere I could read about it pleaseIgnored
DislikedHi jubu,
Still no luck but I think I know what's wrong now that I have had a look at the source code.
Do you happen to use a 4 digits broker ?Ignored
DislikedYap... gj Khad, that was the problem. I use a 4 digit broker and i can see that many of you guys use a 5 digit broker. I've fixed that problem and made it so that it works on a five digit broker too (tested on Alpari). This version posted below v2.1 works on a 4 and 5 digit broker but if you have a 4 digit broker i would recommend you to get the v2.0 posted previously because that one works best on it. For example v2.1 will not work on a 3 digit pair from a 4 digit broker account and also it won't work on a...Ignored