I dont get this one, if anyone can help much appreciated.
I am simply trying to modify the Support-Resistance(Barry) indicator to change the windings it uses on the fractals to a smaller version.
So simply the code is:
where i have changed the windings from 119 to 115.
So the odd thing is it works - ONLY after i recompile the indicator.
So every time i place it on a chart, its still got the original windings, when i recompile it goes to my modified ones, then if i change TF it reverts back !?
The code is quite small - i cannot see references anywhere to the original windings it is reverting to - any ideas ??
Thx
I am simply trying to modify the Support-Resistance(Barry) indicator to change the windings it uses on the fractals to a smaller version.
So simply the code is:
Inserted Code
SetIndexArrow(0, 115); SetIndexArrow(1, 115);
So the odd thing is it works - ONLY after i recompile the indicator.
So every time i place it on a chart, its still got the original windings, when i recompile it goes to my modified ones, then if i change TF it reverts back !?
The code is quite small - i cannot see references anywhere to the original windings it is reverting to - any ideas ??
Thx