Hi again.
I tested 50, 20 in 15 minutes, where a crossover had occurred and I did get the alerts fine. We just need to wait for one to occur under 1 hour I guess to check.
Another reason I can think of is the following.
-Maybe the crossover had occur in that hour, but after a while the moving average is at the same state as it was the previous hour. (ie the 50 MA went above the 20MA for a few minutes but later on went bellow it again).
-If this was the case the alarm would not ring again until the moving average changes state again, as it could be considered a false signal
Regards
I tested 50, 20 in 15 minutes, where a crossover had occurred and I did get the alerts fine. We just need to wait for one to occur under 1 hour I guess to check.
Another reason I can think of is the following.
-Maybe the crossover had occur in that hour, but after a while the moving average is at the same state as it was the previous hour. (ie the 50 MA went above the 20MA for a few minutes but later on went bellow it again).
-If this was the case the alarm would not ring again until the moving average changes state again, as it could be considered a false signal
Regards